ProScan PS20112 Especificaciones descargar pdf (Pagina 50)

• ,, z_ v _ v • • v-

Troubles sometimes are caused by simple "faults" that you

can easily correct without the help of a service technician by

first checking a few basic remedies.

Before you call or take your unit to an Authorized ProScan

TV Servicenter, look below for the type of trouble you are

experiencing. Then perform the simple checks and

adjustments listed for that trouble.

'IV will not turn on

• Check to make sure it is plugged in.

• Check the wall receptacle (or extension cord) to make sure

it is "live" by plugging in something else.

• Maybe batteries in remote control are "dead".

• Maybe remote control was not aimed at remote sensor.

• Make sure power cord is fully inserted into back of TV.

Controls don't work

• If using remote control, make sure remote is in "TV Mode"

by first pressing rv button.

• Try unplugging set for two minutes and then turning it on

again.

• Make sure power cord is fully inserted into back of TV.

Turns off while playing

• SLEEPTIMERfunction may have been activated.

• ALARMOFFfunction may have been activated.

• Electronic protection circuit may have been activated because

of a power surge. Wait 30 seconds and then turn on again. If

this happens frequently, the voltage in your house may be

abnormally high.

• Make sure power cord is fully inserted into back of TV.

Turns on unexpectedly

• ALARMONfunction may have been activated.

ALARMdoes not turn offTV at correct time

• Check ALARMON/OFF function. Must be set to ON

• Check to make sure CLOC_function is set to the correct time.

Blank screen

• Maybe Channel 90, 91, or 92 is selected, but device connected

to those INPUTjacks is not :urned on.

• Try another channel.

Intermittent or no remote

• Maybe sometl_ing was between the remote and the remote

sensor.

• Maybe*the remote was not aimed directly at the component

(TV or VCR) you were trying to control.

• Maybe remote is not in "TV Mode". Press the rv button so

remote will control TV.

• Maybe batteries in remote are weak or dead. Try replacing

batteries.

• Maybe batteries were installed incorrectly. Try replacing

batteries correctly.

No sound, picture okay

• Maybe sound is muted. Try pressing VOLUMEup button to

restore sound.

• Maybe TV's speakers are _urned off. Check SPEAKERS ON/OFF

function.

• If using channel 90 (s VIOE3input) with an S-VHS component,

remember to also connect :he component's Land a AUDIOOUT

jacks to the TV's Land RINPUT1jacks.

1 2 ... 45 46 47 48 49 50 51 52 53 54

Comentarios a estos manuales

Sin comentarios

ProScan PS20112 Especificaciones Pagina 50

Comentarios a estos manuales

Relacionado con productos y manuales para Televisores Lcd ProScan PS20112