ProScan 19LA20QW Instrucciones de operaciones descargar pdf (Pagina 22)

If the AV device is switched on and correctly connected, and the LCD TV/Monitor is set to AV (or S-VIDEO

if using S-Video cable instead of RGB) then the AV feed will start playing automatically.

When in AV (or S-VIDEO) mode, press the MENU button on the remote control to show the main menu as shown below:

VIDEO ADVANCE

OSD SETTING

RESET

INPUT SOURCE

NO SYNC

The operation and functions of the AV (and S-VIDEO) menu are identical to those in TV mode as described above.

To use your unit as a computer monitor:

1. Press the INPUT button on the remote control until "PC" appears in the top right of the screen.

2. If you do not have a computer connected a blank screen will appear with a box containing the words "NO SYNC". If this

is the case ensure that your computer is powered on and is plugged correctly into the sockets on your LCD TV/Monitor

with the serial cable.

3. To receive sound from your computer through the speakers in your LCD TV/Monitor, connect the single pin audio cable

(supplied) to the AUDIO IN socket on the rear panel of the unit and the other end to the audio out socket on your

computer.

Note: if you cannot receive the video signal on the monitor or it sometimes drops in and out it is because of hardware or software

incompatibility between your computer and the LCD TV/Monitor. Typically this would only occur with older computers with an

older model display card or old operating system. In this case try the following:

Adjust display settings on your computer - with your old monitor connected in place of the LCD TV/Monitor, right-click on

the Desktop and select Properties. Select the Settings tab. Adjust the screen resolution to "640 x 480". Then click

Advanced and go to the Monitor tab, then Monitor Settings. Adjust the Screen Refresh Rate to "60 Hertz". Apply

1 2 ... 17 18 19 20 21 22 23 24 25 26

Sin comentarios

ProScan 19LA20QW Instrucciones de operaciones Pagina 22