ProScan PRD8630A Guía de usuario descargar pdf (Pagina 24)

CHECKING THE CODES

If you have set up the DIRECTV universal remote control

using the Searching For Your Code procedure (on the pre-

vious page), you may need to find out which four-digit

code is operating your equipment. For example, to find

out which code is operating your TV:

1. Turn on your TV.

2. On the DIRECTV universal remote control,

press TV once. Then press and hold Setup until

the TV key blinks twice,then release Setup.

3. Enter 9 - 9 - 0.

4. To view the code for the first digit, press 1 once.

Wait 3 seconds and count the number of LED

blinks (e.g., 3 blinks = 3) and write down the

number in the leftmost TV Code box below.

NOTE: If a code digit is “0”, the LED will not blink.

5. Repeat step 4 three more times for remaining

digits. Use 2 for the second digit, 3 for the third

digit, and 4 for the fourth digit. Finish writing

down the code in the TV Code boxes below.

6. To check for other device codes, repeat steps 1

to 5, but substitute the appropriate key (i.e.,

VCR, AUX,or DIRECTV) for the device you are

checking.Write down the codes in the appro-

priate boxes on pages 10 and 12.

DirectTV Mnl rev1 10/25/01 7:31 PM Page 24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Sin comentarios

ProScan PRD8630A Guía de usuario Pagina 24